richchappy Posted February 11, 2006 Report Share Posted February 11, 2006 I have spent the best part of 2 hours gettin 2 rods set up with rig tubing so can any1 tell me the best way to put your mainline thru rig tubing as i almost commited suicied!!! Quote Link to comment Share on other sites More sharing options...
Guest Anonymous Posted February 11, 2006 Report Share Posted February 11, 2006 buy a tube threader gardner make them or from any tackle shop a diamond eye pole threader £2 and the jobs done. Quote Link to comment Share on other sites More sharing options...
boots_n_braces Posted February 11, 2006 Report Share Posted February 11, 2006 diamond eye pole elasice threader does in in a few minutes. The only easy way ive ever found of doing it Quote Link to comment Share on other sites More sharing options...
delkimtxi Posted February 11, 2006 Report Share Posted February 11, 2006 try steaming the line that you will thread then cut the line on an angle so it slides better Quote Link to comment Share on other sites More sharing options...
mick1396 Posted February 12, 2006 Report Share Posted February 12, 2006 Just buy a tube threader,never mind all that mucking about with steaming etc. as Jemsue says about £2.00 0r £2.50 made by gardner,I`ve been using them for years and wouldn`t be without one. Quote Link to comment Share on other sites More sharing options...
richchappy Posted February 12, 2006 Author Report Share Posted February 12, 2006 just got one today thank god. seriously i was there for about 2 hours seting up 2 rods... Quote Link to comment Share on other sites More sharing options...
mick1396 Posted February 13, 2006 Report Share Posted February 13, 2006 They are a simple bit of kit,but can save a lot of stress! Quote Link to comment Share on other sites More sharing options...
delkimtxi Posted February 13, 2006 Report Share Posted February 13, 2006 i prefair leadcore and safe zone leaders but everyone to their own:D Quote Link to comment Share on other sites More sharing options...
salokcinnodrog Posted February 13, 2006 Report Share Posted February 13, 2006 Diamond Eye tube threader, easy, job done. Had mine for years, only problem is with some of the very thin softtubing that I like to use. Another way is to make sure that you cut the line at an angle so it goes through the tube and then keep the tubing pointing straight down by hanging a lead from the bottom end. I normally have a paper clip with one end I have filed to a point and push it through the very end of the tubing. Hang a lead on it and the tubing stays straight as you thread it. :D Quote Link to comment Share on other sites More sharing options...
mick1396 Posted February 13, 2006 Report Share Posted February 13, 2006 i prefair leadcore and safe zone leaders but everyone to their own:D What do you do on waters that have banned leadcore? or is that not a problem yet? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.