Jump to content

Beginners Tackle and Rigs


djerwood

Recommended Posts

Hi, I am new to the forum and was looking for some advice. 


I did a lot of course/match fishing around 20 years ago, but want to start fishing again and give carp fishing a try.

Have done some research and am looking at the following initial setup.

•    Daiwa Black Widow G50 Rod (12ft / Test Curve 2.75lb)
•    Shimano Baitrunner ST RB Reel (1000RB)
•    Gardner GT-HD Mono Line 15/18lb line
•    Leeda Roque 3 in 1 Rod Pod + Carry Case
•    Nash Siren R3 Alarm
•    Bash Bobbin Kit
•    Korda QC Hybrid Lead Clips
•    Korda Square Pear Swivel Lead (2oz & 3oz)
•    Korda NEW Ready Tied DF Carp Rigs Size 8 Barbless Pack of 5
•    Korda NEW Ready Tied DF Carp Rigs Size 10 Barbless Pack of 5

Q1 - Initial question is, does that sound like a sensible setup? Appreciate everyone will have different ideas and personal favorites, but wanted to check I am not going down the wrong path or missing something major.

Q2 - Additionally, just wanted to confirm I have understood the line setup. In the setup above I would use the line and use a Palomar knot to either a Kora Swivel / QC Swivel Size 8 or Drennan Run Ring. This would then clip on to 1 side of my Hybrid clip. On the other side of the clip the ready tied rigs would clip on. Then the weigh attaches to the Hybrid clip. Bait up and I am ready to go?

Is that the case or have I missed something or using the wrong tackle?

Appreciate and help and comments.

Edited by djerwood
Link to comment
Share on other sites

2 minutes ago, framey said:

You will also need a decent sized net and unhooking mat 

The kit you have listed will get you going and last 

 personally

I would up the rig size to a 6 and 8 and forget the 10’s

 

Great, thank you. Much appreciated.

Do I have the right idea with my line setup (Q2)?

Link to comment
Share on other sites

4 minutes ago, framey said:

You do 

15lb is pretty much standard 

I still have a set of spare spools with 10lb on them for open water use

Thanks, really appreciate it. Is the below OK? 

I would use the line and use a Palomar knot to either a Kora Swivel / QC Swivel Size 8 or Drennan Run Ring. This would then clip on to 1 side of my Hybrid clip. On the other side of the clip the ready tied rigs would clip on. Then the weigh attaches to the Hybrid clip. Bait up and I am ready to go?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...